DRM Technic -- Products -- Pre-Coolers

 

In applications with entrenched liquid droplets or high vapor connect, it is advantageous to have to a

pre-cooler installed upstream from the main cooler to ensure that the sample gas is dried as effectively
as possible before being fed into the main analyser. In some applications, these coolers can be used
as an alternative to a traditional gas cooler (being used either as a stand-alone unit or in combination
with a coalescing filter).

Click for:
Pre-Coolers | Chillers and Scrubbers

PRE-COOLERS





11 LD SPEC. PRE-COOLER
Vertically-mounted pre-cooler with an integrated automatic drain valve, specified for use as an up-stream separator.
Datasheet





165 SS PRE-COOLER
A combination of a centrifugal separator and a coarse filter; capable of removing both moisture and particulate from the gas stream. Made out of Stainless Steel.
Datasheet





167 T-x PRE-COOLERS
Alternate versions of the 165 SS. The 167 T-P Pre-Cooler is made from PTFE and Viton; the 167 T-V from PTFE and Perfluorelastomer.
Datasheet





AK 20 V PRE-COOLER
Vertically mounted pre-cooler, specified for use either as a separator or a stand-alone condensate trap.
Datasheet





TS-10 PRE-COOLER
Vertically mounted pre-cooler with an integrated peristaltic drain pump for condensate removal.
Datasheet


CHILLERS AND SCRUBBERS




161 PVDF SPEC. SCRUBBER
Uses contact between water and the sample gas to reduce the gas'
temperature and remove unwanted components.

Datasheet





170 IST CHILLER
Directs the sample gas through a coil-type heat exchanger which is immersed into a shell through which water is circulated. Available in Stainless Steel and Titanium versions.
Datasheet